Configure Ospf On An Interface - Motorola BSR 64000 Quick Start Manual

RDN(config-rip)# network <ip-address> <wildcard-mask>
where:
3. To set the version of RIP to 1 or 2, use the version command in Router RIP
Configuration mode, as shown in the following example:
RDN(config-rip)# version [1 | 2]
where:
Refer to the following documents for additional instructions:
•
BSR 64000 Configuration and Management Guide
•
BSR 64000 Command Reference Guide

Configure OSPF on an Interface

Follow these steps to set an IP address for the OSPF network on the specified router
interface.
1. To enable OSPF on the specified router interface, use the router ospf command
in Global Configuration mode, as shown in the following example:
RDN(config)# router ospf
2. To enable OSPF announcements on the specified router interface, use the
network command, as shown in the following example:
RDN(config-ospf)# network <ip-address> <wildcard-mask> <area-id>
where:
ip-address is the RIP network address
wildcard-mask is the inverse of the subnet mask of the specified router
interface
1 is for RIP version 1
2 is for RIP version 2
ip-address is the IP address of the OSPF network.
wildcard-mask is the inverse of the subnet mask of the specified router
interface.
Quick Start
13