Electronic Control Modules - BraunAbility Foldout Ramp Maintenance And Service Manual

ELECTRONIC CONTROL MODULES

Diagram - Electronic Control Module Connections / Inputs / Indicators
The control module assembly is
mounted to the bottom of the pas-
senger side third row seat. Re-
moval of this seat is prohibited.
Tip the seat forward to access the
module assembly.
Computer Port - Laptop diagnostic
connection port to the electronic
controller.
Grounding Studs - The controller
assembly provides two grounding
studs.
Indicator LEDs - LED's illuminate
whenever a switch is grounded (as
labeled).
Computer Port
Fuse
Block
Ramp Override
Page 14
Kneel Override - Buttons drive the
kneel system in the direction indi-
cated. The kneel LED will illumi-
nate Red when kneeling and Green
when unkneeling (raising).
Reset Button - Resets controller.
Speaker Enable - Turns the
internal speaker On and Off. The
speaker sounds a tone whenever
an operate signal is seen (any con-
Grounding
Studs
Ramp
Module
Ramp Select Switch
trol switch is activated). A tone will
also sound if the ramp motor pulls
current over the controller preset
baseline current.
Ramp Select Switch - Sets
foldout ramp.
Ramp Override - Buttons drive the
ramp in the direction indicated. The
ramp LED will illuminate Red when
deploying and Green when stowing.
Indicator LEDs
Main
Controller
Reset
Button
Kneel Override
Kneel
Module
Speaker
Enable