Maintenance And Lubrication Schedule - BraunAbility Foldout Ramp Maintenance And Service Manual

MAINTENANCE and SERVICE
Preventive Maintenance
Maintenance is necessary to en-
sure safe and trouble free conver-
sion operation. Encourage the
consumer to perform preventive
maintenance procedures. Gen-
eral preventive maintenance con-
sisting of inspections along with
cleaning procedures should be
a part of the consumers routine.

Maintenance and Lubrication Schedule

Normal vehicle maintenance
must be performed as outlined
in the OEM-supplied owner's
manual. This maintenance is
not the responsibility of The
Braun Corporation.
The maintenance and lubrica-
tion procedures outlined in this
schedule must be performed at
the recommended scheduled
intervals by a Braun authorized
service representative.
Clean
and the surrounding area before
applying lubricants. When re-
placing lubricated components,
be sure to lubricate during instal-
lation procedures.
should be applied where *Light
Oil is called out (goes on wet
and then dries). Lubricants of
this type are available that do
not attract dust and other debris.
Page 4
Keeping the passenger slide door
lower track pan free of debris, ice
and snow is one of the most ef-
fective preventive maintenance
practices to exercise. Regular
preventive maintenance proce-
dures will increase the service
life of the conversion, as well as
enhancing safety.
Use of improper lubricants can
attract dirt or other contaminants
which could result in wear or
damage to components. Avoid
lubricants that can leave stains.
Some lubricants referenced in the
schedule are available from The
Braun Corporation (part numbers
All listed inspection, lubrication
and maintenance procedures
intervals following the scheduled
intervals are a general guideline
and will vary according to fre-
quency of use and conditions.
Exposure to severe conditions
(weather, environment, contami-
nation, heavy usage, etc.) may
require inspection and main-
tenance procedures to be per-
The consumer should inspect and
clean frequently and routinely
(minimum four weeks or 100
cycle intervals).
Note: A Preventive Maintenance
section is provided in the opera-
tor's manual.
Discontinue use immediately
if maintenance and lubrication
procedures are not properly per-
formed, or if there is any sign of
wear, damage, improper opera-
tion or any abnormal condition.
Contact your sales representa-
tive or call The Braun Corpora-
tion at 1-800-THE LIFT ® . One
of our national Product Support
representatives will direct you to
an authorized service technician
who will inspect your conversion.
Maintenance and lu-
brication procedures
must be performed
authorized service
technician. Failure
to do so may result
in serious bodily in-
jury and/or property
damage.