Table of Contents
Advertisement
4) Power tool use and care
a) Do not force the power tool. Use the correct power
tool for your application.
do the job better and safer at the rate for which it was
designed.
b) Do not use the power tool if the switch does not turn
it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or
the battery pack from the power tool before making
any adjustments, changing accessories, or storing
power tools.
Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool's
operation. If damaged, have the power tool repaired
before use.
Many accidents are caused by poorly
maintained power tools.
f ) Keep cutting tools sharp and clean.
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to be
performed.
Use of the power tool for operations different
from those intended could result in a hazardous situation.
h) This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge,
unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
The correct power tool will
Properly
i) Children should be supervised to ensure that they do
not play with the appliance.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
will ensure that the safety of the power tool is maintained.
b) If the supply cord is damaged, it must be replaced by
the manufacturer,
persons in order to avoid a hazard.
Additional safety rules
for wetstone sharpeners
Note.
It is recommended to use in conjunction with this
appliance a Residual Current Device (RCD) of rating not
exceeding 30mA.
•
Always remove the plug from the mains socket before
making any adjustments or maintenance, including
changing the wheel.
•
Always turn the sharpener off when it is not in use and
never leave it unattended without first switching off and
removing the power plug. Never leave the sharpener
until the wheels have come to a complete stop.
•
Make sure that any replacement wheel is rated at 120rpm
or higher.
•
Do not let anyone under 18 years operate this tool.
•
Rags, cloths, cord, string and the like should never be left
around the work area.
•
If you are interrupted when operating the tool, complete
the process and switch off before looking up.
•
Periodically check that all nuts, bolts and other fixings are
properly tightened.
•
Do not use a wheel that has received a blow, especially
to the side of the wheel.
•
Replace a cracked or suspect wheel.
•
Always allow a new wheel to run for a few minutes at full
speed before using it. Stand to one side at start up.
5
its service agent or similarly qualified
This
Advertisement
Table of Contents
