Automatic System Recovery User Commands; Enabling And Disabling Automatic System Recovery; Table 2-3 Virtual Keyswitch Setting For Reset Scenario; Table 2-4 Alom Cmt Variable Settings For Reset Scenario - Sun Microsystems Sun Fire T1000 Administration Manual

The standard system reset protocol bypasses POST completely unless the virtual
keyswitch or ALOM CMT variables are set as follows:
Virtual Keyswitch Setting for Reset Scenario
TABLE 2-3
Keyswitch Value
virtual keyswitch
diag
ALOM CMT Variable Settings for Reset Scenario
TABLE 2-4
Variable Value
normal or service
diag-mode
min or max
diag-level
diag-trigger power-on-reset error-reset
Therefore, ASR is enabled by default. For instructions, see
Automatic System Recovery" on page

Automatic System Recovery User Commands

The ALOM CMT commands are available for obtaining ASR status information and
for manually unconfiguring or reconfiguring system devices. For more information,
see:
"Unconfiguring and Reconfiguring Devices" on page 35
■
"To Reconfigure a Device Manually" on page 36
■
"Obtaining Automatic System Recovery Information" on page 35
■
Enabling and Disabling Automatic System
Recovery
The automatic system recovery (ASR) feature is not activated until you enable it.
Enabling ASR requires changing configuration variables in ALOM CMT as well as
OpenBoot firmware.
Default
normal
max
power-on-reset
33.
Chapter 2 Managing RAS Features and System Firmware
"Enabling and Disabling
33