Fog Lamps; Taillamps, Turn Signal, Stoplamps, Rear Fog Lamps And Back-Up Lamps - Chevrolet Captiva Owner's Manual

FOG LAMPS

To replace one of these bulbs:
1. Open the hood. See Hood on page
9-3.
2. Remove the headlamp assembly.
See Headlamps, Front Turn Signal
and Parking Lamps on page 9-31.
3. Remove the connector retaining tab
(A).
4. Disconnect the wiring harness
connector from the bulb (C) by
pressing the connector release (B)
and pulling straight back.
5. Remove the old bulb from the from
the fog lamp assembly by squeez-
ing the bulb release tabs and pulling
straight out.
6. Push the new bulb into the bulb
assembly until it locks into place.
7. Install the wiring harness connector
to the bulb. Be sure the connector
release (B) locks into place.
8. Install the connector retaining tab
(A).
9. Replace the headlamp assembly.
Vehicle Care 9-33
TAIL LAMPS, TURN SIGNAL,
STOP LAMPS, REAR FOG
LAMPS AND BACK-UP LAMPS
B
C
A
D
Passenger Side Shown, Drive Side
Similar
A. Back-Up Lamp
B. Stoplamp/Taillamp
C. Turn Signal Lamp
D. Rear Fog Lamp