Chevrolet Captiva Owner's Manual page 168

8-12 Driving and Operating
LOCK (STOPPING THE ENGINE/
LOCK/OFF): When the vehicle is
stopped, turn the ignition switch to
LOCK/OFF to turn the engine off.
Retained Accessory Power (RAP) will
remain active. See Retained Accessory
Power (RAP) on page 8-15.
This is the only position from which
you can remove the key. This locks the
steering wheel, ignition, and automatic
transmission. Push in the ignition
switch as you turn the key towards you.
Do not turn the engine off when the
vehicle is moving. This will cause a loss
of power assist in the brake and steering
systems and disable the airbags.
If the vehicle must be shut off in an
emergency:
1. Brake using a firm and steady
pressure. Do not pump the brakes
repeatedly. This may deplete power
assist, requiring increased brake
pedal force.
2. Shift the vehicle to neutral. This can
be done while the vehicle is
moving. After shifting to neutral,
firmly apply the brakes and steer
the vehicle to a safe location.
3. Come to a complete stop. Shift to P
(Park) with an automatic transmis-
sion, or Neutral with a manual
transmission. Turn the ignition to
LOCK/OFF.
4. Set the parking brake. See Parking
Brake on page 8-29.
Warning
Turning off the vehicle while
moving may cause loss of power
assist in the brake and steering
systems and disable the airbags.
While driving, only shut the vehicle
off in an emergency.
If the vehicle cannot be pulled over, and
must be shut off while driving, turn the
ignition to ACC/ACCESSORY.
The ignition switch can bind in the
LOCK/OFF position with your wheels
turned off center. If this happens, move
the steering wheel from right to left while
turning the key to ACC/ ACCESSORY.
If this doesn't work, then the vehicle
needs service.
ACC (ACC/ACCESSORY): This
position provides power to some of the
electrical accessories. It unlocks the
steering wheel and ignition. To move
the key from ACC/ ACCESSORY to
LOCK/OFF, push in the key and then
turn it to LOCK/OFF.
ON (ON/RUN): The ignition switch
stays in this position when the engine is
running. This position can be used to
operate the electrical accessories. This
position can also be used for service and
diagnostics, and to verify the proper
operation of the malfunction indicator
lamp as may be required for emission
inspection purposes.
To shift out of P (Park), turn the ignition