Honda Civic Owner's Manual page 248

06/08/05 22:15:52 32SMG610_248
You can also switch to the normal
audio mode while you are listening to
the traffic information by pressing
the TA/PTY button. It does not
cancel the TA standby function.
To adjust the volume of the traffic
announcement, turn the power/
volume knob while the
announcement is broadcasting. The
adjusted volume level will be stored,
then that level will be used on the
next traffic announcement. You
cannot adjust the volume below the
minimum level. The volume of the
PTY NEWS or the PTY ALARM
function can also be adjusted (see
page 249 ).
If your vehicle's battery goes dead,
or is disconnected, the traffic
announcement volume level will be
reset to the default setting (level 9).
To turn off the TA function, press
the TA/PTY button again. TA will go
Audio System (on vehicles with navigation system)
out from the display. You can also
turn the TA function on or off on the
audio display on the navigation
screen (see page 242 ).
Pressing the TA/PTY button will not
turn off the TA function while you
are listening to the traffic
information. It will just switch to the
selected audio playing mode.
If you use seek or auto select with
the TA function on, the system
searches only TP stations.
PTY (Program Type) Display
Function
This function shows you the
program type of the selected RDS
station. For example, if the station is
broadcasting drama, DRAMA is
shown in the display. If it is a station
of scientific programs, SCIENCE is
shown. The principal PTYs are
shown on page 247 .
Press the AUDIO button on the
control panel to view the audio
display on the navigation screen,
then push down the selector on the
interface dial to select the function
display. Turn the dial to select the
PTY, then press the ENT on the
interface dial.
CONTINUED
Features
245