Honda Civic Owner's Manual page 411

06/08/05 22:38:07 32SMG610_411
Wiper Blades
Do not pull up the end of the
holder forcibly and bend the
holder excessively while removing
the blade. This could damage the
holder.
408
Maintenance
BLADE
REINFORCEMENT
5. Examine the new wiper blades. If
they have no plastic or metal
reinforcement along the back
edge, remove the metal
reinforcement strips from the old
wiper blade, and install them in
the slots along the edge of the new
blade.
6. Install the new blade onto the
blade assembly:
Pull back either end of the blade
assembly.
Place the side of the blade not
labeled ''LOCK'' on the end of
the blade assembly, and slide
the blade onto the assembly
until it is fully installed.
7. Slide the wiper blade assembly
onto the wiper arm. Make sure it
locks in place.
8. Reinstall the cap on the wiper arm
along to the slit on the holder.
9. Make sure the blade is completely
installed and that its edge is not
bunched up.
10. Lower the wiper arm down against
the windscreen, the passenger's
side first, then the driver's side.