Honda Civic Owner's Manual page 171

06/08/05 22:05:41 32SMG610_171
Power Windows
To open or close the driver's or the
front passenger's window partially,
push down or pull back on the
window switch lightly and hold it.
The window will stop when you
release the switch.
When you push the MAIN switch in,
the switch is off, and the passengers'
windows cannot be raised or lowered.
To cancel this feature, push on the
switch again to get it to pop out.
Keep the MAIN switch pushed in
when you have children in the
vehicle so they do not injure
themselves by operating the
windows unintentionally.
The indicators inside the switches
come on when you turn the ignition
switch to the ON (II) position.
168
Instruments and Controls
AUTO REVERSE If either of the
front windows runs into any obstacle
while it is closing automatically, it
will stop, and then reverse direction.
To close the window, remove the
obstacle, then use the window switch
again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
before closing it.
If your vehicle's battery is
disconnected or goes dead, or either
of the front windows' fuses is
removed, the AUTO function will be
disabled. The power window system
needs to be reset after reconnecting
the battery or installing the fuse.
1. Start the engine. Push down and
hold the driver's window switch
until the window is fully open.
2. Pull and hold the driver's window
switch to close the window
completely, then hold the switch
for about 2 seconds.
3. Repeat the above steps on the
front passenger's window.
If the power windows do not operate
properly after resetting, have your
vehicle checked by your dealer.