Adjusting The Blower Speed; Normal Operating Sounds; Normal Operating Odors - Lopi Spirit DV EF Manual

Adjusting the Blower Speed

The blower helps transfer heat from the heater into the room. It will not turn on until the heater is up to
temperature (approximately 10 minutes after starting). See the illustration below for instructions on
adjusting the blower speed.
OFF
Turn the dial all the
way counter-clockwise
until it clicks off.

Normal Operating Sounds

Pilot Flame
The pilot flame, which
remains on, makes a very
slight "whisper" sound.
Gas Control Valve
As the gas control valve is
turned on and off you will
hear a dull clicking sound.
This is the valve opening
up and shutting down.

Normal Operating Odors

This appliance has several areas that reach high temperatures. Dust or other particles on these areas may
burn and create a burnt-paper smell. This is normal during startup. You may notice the smell is more acute
if the appliance was left idle for a long period.
Travis Industries
Operation
HIGH
The high position is all the
way counter-clockwise,
without clicking off.
4041220
LOW
Turn the dial all the
way clockwise.
Blower
This heater uses a blower to push heated
air into the room. You will hear the sound
of air movement that increases as the
speed is increased.
The appliance will creak with change
of temperature.
Blower Snap Disk
This part can produce a clicking sound
as it turns the blower on and off.
Extinction Pops
It is not unusual, especially on Propane
(LP) appliances, to experience a "pop"
when the burner is shut off.
1 0 0 - 0 1 1 5 3
21