Freefly M?VI Controller User Manual page 27

AUXILIARY TRANSMITTER:
The MōVI Controller Receiver can optionally be used as an Auxiliary Transmitter for controlling third-party wireless follow-focus systems. For more information on
supported systems, see the Follow-Focus Integration section. To change modes:
1 - Move the Receiver Channel Switch to the position indicated in the table below.
2 - Hold down the FW Button and then press the Bind Button once.
3 - The new mode will be active after the next power cycle.
MODE
MōVI Controller Receiver
Status LED:
(Solid Green)
Set Channel: 0 - C
Press Bind Button while
holding down FW Button.
microRemote Auxiliary Transmitter
Status LED:
(Slow-flashing green/orange)
Set Channel: D
Press Bind Button while
holding down FW Button.
Axis 1 Auxiliary Transmitter
Status LED:
(Fast-flashing green/orange)
Set Channel: E
Press Bind Button while
holding down FW Button.
Auxiliary Transmitters and Auxiliary Data Port connector are sold separately.
1
CONNECTS TO
MōVI Gimbal Controller, MōVI Data Port.
(See Receiver Installation section.)
MōVI Controller Auxiliary Data Port.
MōVI Controller Auxiliary Data Port.
DESCRIPTION
This is the normal operating mode for
two-way communication from the MōVI
Controller to the MōVI. The Receiver that
comes included with the MōVI Controller
is in this mode by default.
1 In this mode, the MōVI Controller Receiver
acts as an Auxiliary Transmitter for sending
commands to a Redrock Micro microRemote
Basestation.
In this mode, the MōVI Controller Receiver
1
acts as an Auxiliary Transmitter for sending
commands to a Hocus Products Axis 1 Digital
Receiver.