Freefly M?VI Controller User Manual page 26

SYMPTOM
Bind Failed.
Receiver Status LED:
(Slow-Flashing Red) OR
(Solid Red)
A user input (e.g. Pan Speed Knob, Mode
Switch) is not working.
The Pan/Tilt Axes are not working.
POSSIBLE CAUSE
MōVI Controller was not detected.
MōVI Controller did not allow binding.
The input has been remapped in Tx Config.
The input is broken/damaged.
Pan/Tilt Speeds are at their minimum settings.
The MōVI is in Majestic Mode.
SOLUTION
Make sure the MōVI Controller is powered on and in range.
Turn off any other MōVI Controller that might be in range.
Use Radio Config::Radio Action::Bind
the Receiver Status LED changes to slow-flashing orange:
(See binding instructions in the Receiver section.)
Check the assignment of USER 1, USER 2, and USER 3 in the
Tx Config menu to see if the user input in question has been
remapped to one of these.
Many user inputs can be remapped. For example, the Mode
Switch can be remapped to the USER 3 switch. See the Tx
Config menu section for more information.
Increase these setting using the Speed Knobs.
Change to Dual Op. mode using the Mode Switch.
to permit binding after