Installation Guide - GRAPHTEC midi LOGGER GL220 Quick Start Manual

GL220 APS Installation Guide
This guide describes how to install the GL220 application software.
System Requirements
This software can be installed on a PC which fulfills the following
conditions.
OS
CPU
Memory
HDD
Display
Others
To Install the USB Driver
To connect this unit to a PC with the USB interface, a USB driver must
be installed in the PC.
A USB driver and the USB driver installation manual are stored on the
supplied CD-ROM. Install the USB driver according to this manual.
(The manual location: D:\USB Driver\English\GL-USB-UM152.PDF)
Note: D: drive name of CD-ROM. The letter of CD-ROM drive vary it with the
CD-ROM drive of your PC.
To Install GL220 Application Software
To install the application software which sets and controls the GL220,
follow the directions below.
1. Insert the accompanying midi LOGGER GL220 CD-ROM in the PC's
CD drive. Select [Start] -> [Run] to open the [Run] window.
2. In the [Open:] field, type in "D:\English\GL220_820APS\SETUP.EXE"
and press [OK].
3. The installer starts.
("D:" represents the CD-ROM drive. Change this letter to the drive
letter representing your CD-ROM drive, if necessary.)
4. Follow all directions displayed by the installer to continue.
Note: D: drive name of CD-ROM. The letter of CD-ROM drive vary it with the
CD-ROM drive of your PC.
20
: WindowsXP, WindowsVista, Windows 7
: Pentium4 1.7GHz or higher
: 256MB or more (512MB or more recommended)
: 200MB (1GB recommended) additional space required for installing
the application software
: Resolution 1024 x 768 or higher, 65535 colors or above
(16 Bit or higher)
: CD-ROM drive (for installing from CD), USB port required