Setup: How To Make The Settings - GRAPHTEC midi LOGGER GL220 Quick Start Manual

2. Setup: How to Make the Settings

Make the settings required for data capture. Here we will make only those settings that are
minimum requirement. The other settings will be not changed from the factory default settings.
Basic Setup Menu Operation
The
The current position of the cursor on the setup menu is displayed in green. Use the
Points to
Remember !
to move the cursor. If you press the ENTER key at the cursor position, a selection menu or a box
of entering value for selected item is displayed. If you press the QUIT key, the screen closes
and the settings are canceled.
- Examples of selection menu operations (AMP screen)
1. Use the
cursor to the Input parameter of
CH 1 and then press the ENTER key.
(Note: Select "DC" for voltage measurement, and "Humidity" for humidity measurement.)
TIME/DIV
SPAN/POSI/TRACE
QUIT MENU
ENTER
CURSOR DISPLAY
START
STOP
FILE
REVIEW
TIME/DIV
SPAN/POSI/TRACE
QUIT
MENU
ENTER
CURSOR DISPLAY
START
STOP
FILE
REVIEW
10
key, the ENTER key, and the QUIT key are used to set the condition on the setup menu.
keys to move the 2.A selection menu is displayed when
the ENTER key is pressed. Use the
and
1. Press the MENU key to display the setup menu screen.
2. Set Input to "TEMP" and Range to "TC-T" for CH1,
and set Input to "DC" and Range to "1V" for CH2.
(1) Move the cursor to CH1 "Input" and select "TEMP" and then move it
to "Range" and select "TC-T." to "Range" and select "TC-T." to "Range" and select "TC-T." to "Range" and select "TC-T."
(2) In the same way, move the cursor to CH2 "Input" and select "DC" and (2) In the same way, move the cursor to CH2 "Input" and select "DC" and (2) In the same way, move the cursor to CH2 "Input" and select "DC" and (2) In the same way, move the cursor to CH2 "Input" and select "DC" and
then move it to "Range" and select "1V."
3. Select "Off" for all the other channels.
(1)Using the procedure described above, select "Off" for CH 3 to CH 10. (1)Using the procedure described above, select "Off" for CH 3 to CH 10.
keys to select "TEMP."
3. Press the ENTER key to confirm your
selection.
keys