Assembling Pedestal - Fujitsu 9811 ATB Operator's Manual

Installing the Printer
6. Assembling Pedestal and Bin-feeder
Printer, Bin feeder and Pedestal are assembled through four steps as following
1 step: Moving casters to the pedestal from stand bin,
st
2 step: Adjusting height of the pedestal to fit a counter height
nd
3 step: Mounting the bin-feeder and the printer.
rd
4 step: Mounting F9811 printer
th
1 step: Moving caster
st
1. Move four casters to bottom of the pedestal from
the bin feeder. Refer to photo 1,2.
Please use the same screws which are used
on the stand bin.
2 step: Adjusting the pedestal height
nd
Shift down both side frames after removing the
screws, and fix them again so that positioning dowels
meet the positioning holes at expected height.
4 kinds of height are selected as below drawing 1.
Upper side frames
30 cm
Middle side frames
Lower side frames
30 cm
Screws
Positioning Dowels
Positioning Dowels
25 cm
Front bar
Drawing 2
Ball Casters
Pedestal
Screws
20 cm
Rear bar
25 cm
Positioning Holes
15
Photo 1
Bin feeder
Drawing 1
15 cm
20 cm
Upper frames
Positioning Holes
Middle frames
Lower frames
Photo 2
Photo 3
Photo 4
15 cm