Section J : Programming The Heater; Setting The Day Of Week And The Time - Monitor M2200 Owner's Manual

SECTION J
PROGRAMMING THE HEATER
SETTING THE DAY OF WEEK AND THE TIME
Step 1 :Set the Day of Week
Press the "SELECT" Button, at which time the "DAY SET"
Light will illuminate. The "Mon" Light will illuminate and
flash at this point.
Illuminate and flash the Light of the current day of the
week (e.g.; "Wed") by pressing the "UP" or "DOWN"
Button, and then press the "SET" Burton to lock into
memory. The current day (e.g.; "Wed") light will illuminate
continuously.
Step 2:Set the Time
Press the "SELECT" Button, at which time the "CLOCK
SET" Light will illuminate. The LED indicator in the Display
Window will show 88:88 at this point.
Step 3:Set the Hour
Press the "HOUR" Button until the correct hour (either
A.M. or P.M.) appears in the window.
NOTE:The "HOUR" and "MINUTE" Buttons can be
pressed and held or pressed momentarily to
change the time.
Step 4:Set the Minute
Press the "MINUTE" Button until the correct time appears
in the window.
Immediately press the "SET" Button.
NOTE:If the "SET" Burton is not pressed within 1 minute
after the time set, the programming will be
cancelled.
WEEKLY TIMER CONTROL
Mon Tue Wed Thu
O O O
S Sat Sun
O O
DAY SET CLOCK SET TIMER SET
O O O
SET
TEMP
AM
PM
TIMER SELECTOR
ROOM
CD BURN
O EMPTY
SELECT
Hold down (or 3 sec.
, /O
ECONOMY (CHILD
PLUS/ VLOCK
OPERATION
Fig. 33
22