Section E: Fueling; Fueling Options Available; External Tank Installation - Monitor M2200 Owner's Manual

SECTION E
FUELING
Z?\ WARNING : Use only crystal clear kerosene (Red dyed or clear kerosene or low sulphur #1 oil). Never use
gasoline, white gas, camp fuel or other flammable liquids. Use of such Fuels can result in an explosive
fire and cause severe injury. Do not use *2 Home Heating Oil.
FUELING OPTIONS AVAILABLE
Fueling of your Monitor 2200 can be accomplished in
one of the following ways.
1. Optional Capsule tank :
Available from your dealer.
2. Gravity Fed Large Capacity External Tank:
Practical for large heating needs where bulk delivery
of kerosene is available. This system should be
installed by a qualified plumber or fuel supply
technician.
3. Large Capacity External Tank with Pump:
For large heating needs where a gravity fed system
is not practical. An electric lifter pump, especially
designed for use with your Monitor 2200 heating
system, is available from your dealer.
When using a gravity fed tank or pumping system to
supply fuel, the inlet pressure to the heater must not
exceed 2.5 psi.
NOTE:lt is recommended to install the fuel line on the left
side of the unit, with an appropriate shut-off
valve, and then across, behind the unit, to the
attachment point on the right rear of the heater.
NOTE 2: When using a external fuel tank with your
Monitor2200 the"Empty"light will NOT signal
an empty tank. Watch the gauge on the tank to
avoid running out of fuel.
EXTERNAL TANK INSTALLATION- Gravity Fed
PREPARATION AT HEATER
Stepl:
Remove the nut at the rear lower side of the heater.
Collect fuel draining from the heater into a container.
Hold the nipple with a wrench and loosen the nut with
the other wrench (see Figure 21).
Nipple
\
Wrench
Nut Container
Fig. 21
Step 2 :
Insert the rubber plug into the disconnected pipe (see
Figure 22).
If the Monitor 2200 is used to replace a Monitor 22 or 422,
please note that the fuel inlet of the Monitor 2200 is lower
than the M22 or M422.Some adjustment in the fuel line
may be necessary.
Rubber Plug
Bend the pipe aside
Fig. 22
Step 3 :
Connect the fuel line from External Tank as follows.
15