Section D: Heater Installation - Monitor M2200 Owner's Manual

SECTION D
HEATER INSTALLATION
Step 1: Fill Out Owner Registration Card
Remove your owner registration card from the plastic
envelope containing the owner's guide. It should be
filled out and mailed as soon as possible.
Step 2: Check for Parts
Before discarding packing materials, be sure you have
located the following:
Flue Pipe
Sleeve Nut
Spill Tray
Room Temp. Sensor (attached to the rear of the
heater)
Cardboard Template
"STANDARD" Damper
"EXTENSION" Damper
Body Clamp
Rubber Packing
Joint Pipe
Cloth Insulation Cover
Outer Flange
Pipe Holder
Small Bag of Screws
Tapping, Type A -
Tapping, Type A —
For securing
sleeve and
body clamp
For securing
body clamp
SIZE
Tapping
Tapping
Fig. 3
Step 3: Choose a Location for Your Heater
In choosing a location for your heater, the following
guidelines must be considered:
• The heater MAY be installed on combustible floors.
• The area around the heater should be free of
obstacles that might interfere with the free flow of
air. Allow the clearances shown in Figure 4.
12" (30cm)
5
1/
2
"
(13.5cm)
6"
(15cm)
Fig.4
39"
(100cm)
If the unit is installed so that it is enclosed on both sides
and top, the following instructions shall be carried out.
With the side and top clearances as shown in Fig. 5a,
the Monitor shall not be placed so that its front surface
is inside of the enclosure.
6"min
(15cm)
(13.5cm)
6"min
(15cm)
Fig. 5a
Fig. 5b
ZJA CAUTION:
• The heater must not be installed in a fireplace.
• An AC wall outlet must be within reach of the
heater's power cord. Extension cords must not be
used.
• The area outside where the flue pipe will emerge
should be free of foliage, fuel storage tanks and
flammable objects. Air should circulate freely in
the area. Allow the clearances shown in Figure 6 on
the next page.
• The wall where flue pipe hole will be cut should be
free of plumbing pipes, electrical wires, studs, air
ducts and other obstacles.
NOTE:Use the cardboard template provided with your
heater for flue pipe location.