Rear Panel Features - Extron electronics DVI DA2 User Manual

Rear Panel Features

a
DVI-D INPUT
POWER
12V
0.4A MAX
LOCAL MONITOR
1 2
DVI-D INPUT
POWER
12V
0.4A MAX
LOCAL MONITOR
Figure 3.
DVI DA2 (top) and DVI DA4 (bottom) Rear Panels
Power input — Connect the provided power supply to the 3.5 mm, 2-pole captive
screw power receptacle.
POWER
Smooth Ridges
12V
0.4A MAX
A A
Power Supply
Output Cord
DC Power Cord
Captive Screw Connector
Ground
+12 VDC
AC Power Cord
Figure 4.
Power Connection
CAUTION: This product is intended to be supplied by a Listed Power Unit marked
"Class 2" or "LPS", rated 12 VDC, maximum 1.0 A. Always use a
power supply supplied or specified by Extron. Use of an unauthorized
power supply voids all regulatory compliance certification and may cause
damage to the supply and the end product.
Unless otherwise stated, the AC/DC adapters are not suitable for use in
air handling spaces or in wall cavities. The power supply is to be located
within the same vicinity as the Extron A/V processing equipment in an
ordinary location, Pollution Degree 2, secured to the equipment rack
within the dedicated closet, podium, or desk.
The installation must always be in accordance with the applicable
provisions of National Electrical Code ANSI/NFPA 70, article 75, and the
Canadian Electrical Code part 1, section 16. The power supply shall not
be permanently fixed to building structure or similar structure.
DVI-D OUTPUT
1 2
4 3
DVI-D OUTPUTS
1 2
SECTION A–A
External
Power Supply
(12 VDC, 1 A )
DVI DA2 and DVI DA4 • Installation
DVI DA2
DVI DA4
3 4
4