Setting Silent Control Operation - Electrolux Built-in Wall Oven Service Manual

14
Section B - Electronic Controls

SETTING SILENT CONTROL OPERATION

The or
Silent Control operation feature allows the oven control to be operated without sounds or
beeps whenever necessary. If desired the control can be programmed for silent operation
and later returned to operating with all the normal sounds and beeps.
To change control from normal sound operation to silent control
operation:
1. To tell if your range is set for normal or silent operation press and hold
Figure 1
2. Press
operation mode. The display will show either ":SP" (Figure 2) or ":--" (Figure 3).
Figure 2
If ":SP" appears (Figure 2), the control will operate with normal sounds and
beeps. If ":- -" appears (Figure 3), the control is in the silent operation mode.
3. Press
Figure 3
ADJUSTING OVEN TEMPERATURE
The temperature in the oven has been pre-set at the factory. When first using the oven, be
sure to follow recipe times and temperatures. If you think the oven is too hot or too cool,
the temperature in the oven can be adjusted. Before adjusting, test a recipe by using a
temperature setting that is higher or lower than the recommended temperature. The
baking results should help you to decide how much of an adjustment is needed.
To adjust the oven temperature:
1. Press
Figure 4
2. To increase the temperature use the number pads to enter the desired change.
(Example 30°F)
much as 35°F (17°C). To decrease the temperature use the number pads to
Figure 5
enter the desired change. (Example -30°F)
3. Press
Figure 6
to the time of day (Figure 7). Press
necessary.
Figure 7
and or pads control the Silent Control operation feature. The
for 7 seconds. "0:00" will appear in the display (Figure 1).
or to switch between normal sound operation and silent
or to accept the change or press
or for 8 seconds (Figure 4).
(Figure 5). The temperature may be increased as
(Figure 6). The temperature may be decreased as much as 35°F (17°C).
or to accept the temperature change and the display will return
or to reject the change.
and then Press
or to reject the change if
or
or