Light Transformer - Electrolux Built-in Wall Oven Service Manual

32
Section D - Replacement of parts
1.0 HOW TO REMOVE THE OVEN FROM THE CABINET
Figure 1
2.0 HOW TO REMOVE THE PANELS TO ACCESS TIMER,
CONVECTION MOTOR, BLOWER MOTOR, LATCH MOTOR, LATCH
ROD, OVEN TEMPERATURE PROBE, BOARD RELAY, SAFETY
THERMOSTAST, LIGHT TRANSFORMER
Figure 2
Figure 3
1. Disconnect wall oven from electrical supply.
2. Insert tool supplied with the appliance both side at the
same time in the hole located on the side frame and
visible when the oven door is opened.
3. After inserting tool pull the oven towards you.
1. Disconnect wall oven from electrical supply.
2. Remove wall oven from the cabinet. (section 1.0)
3. Remove the 11 screws from the back panel. (Figure 2)
4. Remove the 2 screws on top of control shield. (Figure 3)
5. Remove the 2 screws each sides of the control shield.