Disassembly Procedures; Disconnecting Wire Terminals; Outer Case - Amana Menumaster DECS11MA Service

Disassembly Procedures

!
WARNING
High voltage is present at the high voltage terminal of the
high voltage transformer during any cooking cycle.
It is neither necessary or advisable to attempt
measurement of the high voltage.
Before touching any oven components or wiring, always
unplug the oven from its power source and discharge
capacitor.

Disconnecting Wire Terminals

All wire terminals are locking-type terminals.
Proceed as follows to disconnect wire terminals:
Insulated terminals:
Grasp insulator pod and pull back.
DO NOT PULL ON WIRE.
1 Grasp
Insulator
Pod
Non-insulated terminals:
Use a small blade screwdriver to depress locking-tab and
pull on terminal.
DO NOT PULL ON WIRE.
1 Release
locking-tab
2 Pull
©2005 Maytag Services
To avoid the risk of electrical shock, personal injury, or death,
disconnect power to oven and discharge the capacitors before
following any disassembly procedure.
Wire
2 Pull
Wire
16025963

Outer Case

1. Disconnect power to oven.
2. Remove screws securing outer case to unit.
3. Slide outer case towards rear of unit.
4. Reverse procedure to reassemble.
!
CAUTION
During disassembly some foam gaskets may require
removal. These components must be replaced for
proper circulation of air over the components and
through the oven cavity.
25