Disassembly; Door Removal; Inner Door/Window Removal; Door Disassembly - Amana CRC18T2OG Service Manual

Disassembly

!

Door Removal

1. Unplug power cord from power source.
2. Remove outer case cover.
3. Remove bolts securing door hinges.
4. Remove door from unit, and lay door on padded
surface.

Inner Door/Window Removal

1. Open oven door.
2. Remove screws on hinge side.
3. Beginning at the bottom, carefully insert 1" putty knife
between inner and outer door. Pry up on inner door
to release tabs, (2 tabs per side). Work in a
clockwise direction to release all tabs, see illustration
below.
2
Tabs
1
!
When glass retainer is removed, be careful glass
does not fall out of frame.
RS2240002 Rev. 1
WARNING
3
Remove
screws
4
CAUTION
To avoid the risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.
Hinges
Retainer
lens
Window
outer
0261
0281
Door
outer

Door Disassembly

1. Remove door from oven, see "Door Removal"
procedure.
2. Perform "Inner Door/Window Removal" procedures,
step 1 through step 3 above.
3. Remove door latch linkage plate from latch assembly.
4. Remove screws securing door ring weld, (2 screws
under latch linkage and 2 on hinge side of outer
door).
5. Remove door ring weld from door.
6. Remove lens retainer and outer window from door.
7. Remove screws securing handle/door latch bracket
to gain access to latch spring.
8. Reassemble in reverse order.
9. Proceed to "Interlock Switch Replacement / Door
Adjustment" procedure.

Door Handle

1. Follow "Door Disassembly" procedure through step 6.
2. Remove screws securing latch assembly to outer
door.
3. Reassemble in reverse order.

Hinge

1. Follow Door Disassembly procedure through step 6.
2. Replace hinge on door ring weld.
3. Reassemble in reverse order.
26
Inner
Door
door
ring
weld
*
*
*
*
*
*
*
*
*
*
* *
*
* *
Door
*
*
*
*
latch
*
*
*
linkage
*
*
*
Door
latch
bracket