Quick Start Reference Guide; Interrupting Operation - Amana Menumaster DECS11MA Service

The switching operation of this
microwave oven can cause voltage
fluctuations on the supply line. The
operation of this oven under
unfavorable voltage supply conditions
can have adverse effects. This device
is intended for the connection to a
power supply system with a maximum
permissible system impedance Zmax
of 0.2 Ohms at the interface point of
the user's supply. The user has to
ensure that this device is connected
only to a power supply system which
fulfills the requirement above. If
necessary, the user can ask the public
power supply company for the system
impedance at the interface point.
Part No.12804404
Revised 10/04
A–2

Quick Start Reference Guide

Refer to Product Safety Manual for Safety Statements
Complete Owner's Manual available online
A
C
DO NOT power spray
So...how do I use it?
Heating
1. Open oven door, place food in oven, and close oven door.
2. Turn time entry knob clockwise to desired time.
• Cooking time can be set up to 6 minutes.
• Oven begins operation and time counts down.
3. When cooking time has elapsed, microwave energy stops and oven
signal sounds.

Interrupting Operation

Open oven door to interrupt operation or turn time entry knob
counterclockwise to "0".
To resume microwave oven operation, close door and turn knob.
Changing Time and Canceling Mistakes
Heating time can be changed at any time while the oven is operating. Turn
knob to desired new setting. To set cooking time to zero, turn knob
counterclockwise to "0".
F
or full product documentation visit:
™ www.amanacommercial.com/wavelink
16025963
Oven Wall Clearances
A—For North American (UL/CSA) models,
allow at least 2" (5.1 cm) of clearance
around top of oven. For International (50 Hz)
models, allow at least 12" (30 cm) of
clearance around top of oven. Proper air
B
flow around oven cools electrical
components. With restricted air flow, oven
may not operate properly and life of
electrical parts is reduced.
B—Allow at least 2" (5.1 cm) between air
discharge on back of oven and back wall.
C—Allow at least 2" (5.1 cm) of clearance
around sides of oven.
No metal pans
(Mechanical Dial)
© 2004 Amana Appliances
Amana, Iowa 52204
©2005 Maytag Services