Martin Mania EFX500 User Manual page 11

Always use a secure means of secondary attachment that can
hold at least 10 times the weight of the fixture, looping it
through the attachment point shown at F in "Overview" on
page 4. Do not simply pass the secondary attachment around
the mounting plate, as this will leave the fixture unsecured.
Beam angles and fixture or ient at ion
The fixtures in the Mania EFX series have different optical configurations.
Referring to the illustration below will help you decide how to orient your
fixture.
EFX500, EFX600 EFX700 EFX800
Surface mounting
To mount the fixture on a surface, you will need four grade 8.8 (minimum)
8mm diameter, 13mm head hex screwbolts (or similar type fasteners of
the same grade and size) and an eyebolt for the safety cable.
Installing the mounting plate separately
Surface mounting is easiest if you detach the mounting plate from the
fixture, bolt the mounting plate to the surface, and then reattach the
fixture. If you choose this method, access for reattachment and
adjustment can be easier if you remove the swivel locks and replace them
with two M8 hexagonal lock nuts (P/N 08132701). Install an eyebolt and
safety attachment once the fixture is mounted.
Installing the fixture and mounting plate as a unit
If you prefer to install the fixture and mounting plate without separating
them:
1. Using the inside back cover of this manual as a guide, drill three holes
in the positions marked A.
Installation 11