Servicing Procedures; To Remove The Hob Top And Tray; To Remove The Cooktop From The Bench/Countertop; To Remove An Electrode - Fisher & Paykel GC912 series Service Manual

599328A
5.

Servicing Procedures

Refer to the Service requirements before servicing, Section 1 page 6

5.1 To remove the hob top and tray

1. Lift off the trivets and burner components.
2. Remove the knobs.
3. Remove the screws securing each burner to the hob tray.
To prevent damaging the screw head use a No. 1 Phillip's head screwdriver.
4. Lift the hob tray out of the hob top.
5. Remove the hob top.

5.2 To remove the cooktop from the bench/countertop

Note: It is easier to service the internal components by removing the hob top and tray
rather than removing the product from the bench.
1. Unplug the electrical supply lead.
2. Turn off the gas supply and disconnect the inlet gas pipe.
3. Loosen the cooktop clamping brackets.
4. Lift the cooktop out of the bench.

5.3 To remove an electrode

1. Remove the hob top and tray.
2. Remove the electrode locating clip on the burner bowl.
3. Unplug the electrode lead from the ignition box.

5.4 To remove the ignition box

1. Remove the hob top and tray.
2. Remove the neon mounting bracket by pulling it upward (GC913 only).
3. Unplug the electrode leads and the multi-way plug from the ignition box.
4. Lift off the ignition box attached to the basepan by double-sided tape.
Note: The electrode leads must be plugged into the correct terminals on the ignition box.
Terminal numbers on the ignition box correspond as follows:
S1 Front left burner
S2 Front right burner
S3 Middle burner
S4 Rear left burner
S5 Rear right burner
10