Servicing Procedures; To Remove The Hob Top And Tray; T O Remove The Cooktop From The Bench / Countertop; To Remove An Electrode - Fisher & Paykel CG913T Service Manual

599266B
6.

Servicing Procedures

Refer to the Service requirements before servicing, Section 1 page 6

6.1 To remove the hob top and tray

1. Lift off the trivets and burner components.
2. Remove the knobs.
3. Remove the screws securing each burner.
To prevent damaging the screw head use a No. 1 Phillip's head screwdriver.
4. Lift the hob tray out of the hob top.
5. Remove the hob top.
6.2 To remove the cooktop from the bench
Note: It is easier to service the internal components by removing the hob top and tray rather
than removing the product from the bench.
1. Unplug the electrical supply lead.
2. Turn off the gas supply and disconnect the inlet gas pipe.
3. Loosen the cooktop clamping brackets.
4. Lift the cooktop out of the bench.

6.3 To remove an electrode

1. Remove the hob top and tray.
2. Remove the electrode locating clip on the burner bowl.
3. Unplug the electrode lead from the ignition box.

6.4 To remove the ignition box

1. Remove the hob top and tray.
2. Remove the LED bracket by pulling it upwards and unplug the LED harness from the ignition
box.
3. Unplug the electrode leads and the multi-way plugs from the ignition box.
Note: The electrode leads must be plugged into the correct terminals on the ignition box.
Terminal numbers on the ignition box correspond as follows:
S1 Front right burner
S2 Front left burner
S3 Middle burner
S4 Rear left burner
S5 Rear right burner
S6 Not used
12