IMPORTANT SAFETY INSTRUCTIONS When using this electronic device, basic precautions should always be taken, including the following: 1. Read all instructions before using the product. 2. Do not use this product near water (e.g., near a bathtub, washbowl, kitchen sink, in a wet basement or near a swimming pool etc).
CONTENTS: Before you start What's in the box Features Hints on installation Controls and connections Front panel Rear panel Connectors Cable wiring examples Application example Specifications Block diagram Specifications...
24V power supply are collected in to this device, to make iMIX 63 more flexible and easy adapted to various of installations. Please read this manual carefully to get the most important information about your new unit.
Front Panel 1. INDICATION These green LEDs indicate audio signal in 6. EQUALIZER the input. 3 band: low, mid and high equalizer. Center frequency of the “LOW” tones 2. VOLUME COMBO XLR equalizer is 80Hz, adjusting level ±15dB. The These rotary knobs are for adjusting “MID”...
Rear Panel 1. FUSE HOLDER 7. REC OUTPUT Use T315mA 250V fuse only. Contact This is line level, unbalanced stereo with qualified service if fuse blows up output, RCA connector. Signal in this constantly. output is independent from master, mono or monitor knobs. The signal 2.
Connectors TR connector TRS connector XLR male connector XLR female connector RCA connector Cable wiring examples Cable to balanced input from balanced output. TRS connectors.
Page 8
Cable to unbalanced input from balanced output. TRS and TS connectors. Cable to balanced input from unbalanced output. TS and TRS connectors. Cable to unbalanced input from unbalanced output. TS connectors. Cable to balanced input from balanced output. XLR connectors. Cable to unbalanced input from balanced output.
Page 9
Cable to balanced input from balanced output. TRS and XLR connectors. RCA cable. Cable to unbalanced input from RCA output. RCA and TS connectors. Cable to balanced input from RCA output. RCA and XLR connectors. Cable to balanced input from RCA output. RCA and TRS connectors. Cable to RCA input from balanced output.
Specifications Power supply AC 230V, 50Hz or 24V DC DC 24V power consumption 9,6W AC power consumption 10,5W Phantom power voltage 18V - 20V Combo input gain (line level) -12dBu Maximum input level +12dBu Combo input gain (Mic level) -52dBu Maximum input level -15dBu RCA input gain...