Stopping Fan; Listening To Data By Sound - Teac LX-100 Series Instruction Manual

Stopping Fan

You can stop the cooling fan on the LX by clicking the fan button on the toolbar. (If you have already stopped
the fan and recording of data, wait for about 10 minutes before you again stop the fan and record.) This
button behaves differently depending on the Fan setting in the System dialog.
When the Fan is set to ON
The fan button is enabled after the recording-standby status is established. By clicking the button you can
stop the fan from that moment until you click it again. You can repeat this until the total fan-stop time is 10
minutes. The remaining fan-stop time is shown on the status display.
When Fan is set to OFF
The fan button is enabled only during the recording-standby status. By clicking the button you can stop the
fan only once for a maximum of one minute. The remaining fan-stop time is shown on the status display.
After you start recording, the fan button is disabled and the cooling fan is stopped for 10 minutes.

Listening to Data by Sound

You can play back the data of the monitored channel as sound by clicking the speaker button on the toolbar.
When you click this button during reproduction, the data of the monitored channel instead of a voice memo
is played back from the speaker.
5-21
Convenient Features