EverFocus Paragon 264 Series Instruction Manual page 108

 Once you have a straight through cable plug one end into the LAN port on the back of the recorder
and the other into the high speed modem.
 Log into the EverFocus DVR menu and go to the Network Setting Menu.
 Input the Static IP address, the Subnet Mask, and the Gateway that you obtained from the internet
service provider.
 Note: If you have a dynamic IP address, you can set the DVR to DHCP to automatically detect
the network settings settings. Therefore, it can use a dynamic IP address.
 Exit from the DVR's Menu to save the settings.
 To access the DVR from a computer, open Internet Explorer and in the address bar type:
http:// (IP address given by your internet service provider)
 Note: When using this type of connection, only one device can be connected to the modem at
a time. You will need to use a computer at a different location to test the connection.
101