Advertisement
ARMRESTS
1
Never pick the wheelchair up by grasping the armrests. Only solid and fixed parts of the
framework should be used for transport.
The armrest containing the driving electronics can only be removed if the electronic unit has been
removed (see the Section "Driving electronics").
The armrests may only be lowered or removed when you are quite sure that the user of
the wheelchair is secured against tipping over sideways.
If you detect damage or wear in the armrest supports, contact your dealer who can correct these
deficiencies.
To avoid endangering your own safety, do not use the wheelchair when changes, damage, or
wear are noticed in the suspensions.
Any changes made to the armrests and or armrest supports are at your own responsibility.
Your warranty claim then expires immediately.
DRIVING ELECTRONICS
When the motors are activated, you can set the wheelchair in motion by means of the steering (see
Figure A).
Figure A
1
The height of the armrests can be adjusted by loosening
handle (1) and pulling it up or pushing it down.
To adjust the width between the armrests, loosen screw (2)
and push it to the desired position. Then retighten the screw.
Before using the wheelchair, make sure that all
screws are tightened properly to prevent injury and/or
damage.
Adjustments should be carried out in such a way that
2
the stability of the armrests is not endangered.
To release the motors, turn the motor lever (1)
outwards on each side.
1
The wheelchair can only be driven if the motor lever
(1) points backwards. Before use the lever should be
turned to the desired position.
RAPIDO Instructions Manual
For electronic driving
Status: April-03
connect the motors.
8
Advertisement
