Advertisement
When a helper is pushing you, you should note that backwards rolling forces are increased by the
large weight of the electric wheelchair itself.
If the helper cannot exert sufficient force for pushing the wheelchair uphill, you must immediately
secure the wheelchair by engaging the motor controls.
Take note of the ratings for the maximum loads for the ramps used.
Secure yourself in your wheelchair by means of a safety belt.
We do not accept any liability for damage suffered by you or the wheelchair caused by
improper choice of ramps.
ACCESSORIES
INDIVIDUAL HEADRESTS (L55)
We offer an individually adjustable headrest to fit the standard backrest unit. This consists of a
cushioned headrest that can be set in different positions by means of toothed gears (see Figure).
The headrest must be fixed at least 6 cm above the lower end of the tube and properly
secured by means of the fixing screw.
The height of the headrest can now be adjusted by slightly loosening the adjusting screw until the
toothed gears can be moved. The headrest can now be set to your requirements and then the support
can be secured by retightening the adjusting screws. You can repeat this procedure until you are
happy with the position.
The correct adjustment means that the back of your head is supported in a relaxed upright
sitting position.
Before using the headrest, all fixing screws must be tightened, otherwise the headrest might
slip downwards or sideways and cause injuries.
If you want to secure the attitude of your head, then adjust the two side rests to the dimensions of your
head by pushing them gently inward and forward. This will protect your head against tipping sideways.
Make sure that your head does not exert too much pressure on the side rests, since that might
result in squashing.
Do not slam the side rests together as they might break off and this could cause injury and
loss of function.
If the headrest is changed structurally, no liability will be accepted.
RAPIDO Instructions Manual
The height of this headrest can be
adjusted to your requirements by
inserting it into the socket provided.
This socket is bolted to the upper third
of the backrest, but it should now be
fixed by means of screws in the
proper
position
to
receive
headrest.
Status: April-03
the
16
Advertisement
