Advertisement
•
Messprüfung Ersatzableitstrom (A) nach VDE 0751-1 Measure replacement leakage current
(A) in terms of VDE 0751-1
•
Measure insulation resistance (MO) in terms of VDE 0751-1
•
Check the functioning of the armrests and leg supports (fixing, load, deformation, wear and
tear)
•
Check the operation of the drives (checks during test driving: noises, speed, free running, etc.,
switching off (e.g. current limiting when switching off), if required: measure the performance
firstly without load, then with the rated load (SWL), investigate possible wear of the motors by
measuring the current flow and comparison with the original values.
•
Check the condition of the batteries, upholstery, tubes, and covers.
Measuring checks may only be undertaken by wheelchair tecnicians and skilled electricians
accustomed to the checking means and processes. The release for use of the electric wheelchair after
successful measuring checks and service measures is the job of a skilled electrician.
Servicing should only be included in the service plan if at least the above mentioned profile is
checked. If your dealer does not undertake servicing, you can contact the manufacturer. We shall
gladly provide you with the addresses of specialist dealers in your vicinity.
The manufacturer is not liable for damage caused by omitted or poor servicing.
CARE
To keep your electric wheelchair in a visibly attractive condition, you should regularly do the
following:
COVERS
Clean the artificial leather covers with warm water. In the case of stubborn soiling use a mild
commercial detergent. Stains can be removed by means of a sponge or a soft brush.
In any case, do not let the covers become soaking wet.
Do not use harsh cleaning agents like solvents or a hard brush.
We do not accept liability for damage caused by the use of improper cleaning agents.
Fabric covers should not be soaked.
Steam cleaning is not suitable and you have no warranty claims when that is used.
PLASTIC PARTS
All plastic parts should be treated with commercial plastic cleaners taking note of the special product
information.
PROTECTIVE OUTER LAYER
The special surface treatment guarantees optimal protection agains corrosion. If this is damaged by,
for example, scratches, these could be improved by using a varnish tack available from your dealer.
The movable parts (see also Section "Servicing") should be greased from time to time to ensure that
you can enjoy your wheelchair for a long time.
Chromed parts require dry rubbing. Dull spots or persistent dirt can be removed by using a suitable
chrome polish.
Light greasing with vaseline prevents early dulling of chromed steel.
To keep wheelchair in a good condition for a long time, we recommend that you have it inspected
annually by your dealer. You could confirm these inspections in the "Service plan" Section.
The manufacturer does not accept liability for damage/injury caused by poor servicing and
care.
RAPIDO Instructions Manual
Status: April-03
19
Advertisement
