Table of Contents
Advertisement
Chapter 10
Audio Org
Line Mix: 0-127
This parameter allows you to set the level of Classic Organ sounds in the Line mix. Press [NEXT] to select
this parameter. Use the [+] and [-] (or [++]/[--]) buttons.
Audio Org
Out Level: 0-127
This parameter allows you to set the level of Classic Organ sounds that go to the CLASSIC OUTPUT jacks.
Press [NEXT] to select this parameter. Use the [+] and [-] (or [++]/[--]) buttons.
Audio DBar
Spkr Mix: 0-127
This parameter allows you to set the level of the post-rotary simulator Drawbar sounds in the Speaker mix.
Press [NEXT] to select this parameter. Use the [+] and [-] (or [++]/[--]) buttons.
Audio DBar
Line Mix: 0-127
This parameter allows you to set the level of the post-rotary simulator Drawbar sounds in the Line mix. Press
[NEXT] to select this parameter. Use the [+] and [-] (or [++]/[--]) buttons.
Audio DBar
Out Level: 0-127
This parameter allows you to set the level of the post-rotary simulator Drawbar sounds that go to the
DRAWBAR OUTPUT jacks. Press [NEXT] to select this parameter. Use the [+] and [-] (or [++]/[--])
buttons.
Audio DBar
Rev Send: 0-127
This parameter allows you to set the level of the post-rotary simulator Drawbar signal sent to the W-5000's
reverb unit. Press [NEXT] to select this parameter. Use the [+]/[-] (or [++]/[--]) buttons.
Audio DBar
Sig Switch: On, Off
This parameter allows you to turn the DRAWBAR OUTPUT signal on and off. Press [NEXT] to select this
parameter. Use the [+] and [-] (or [++]/[--]) buttons.
Audio DBar
Freq Resp: Mellow, Norm
This parameter allows you to set the 'tone color' of the Drawbar signal. Press [NEXT] to select this
parameter. Use the [+] and [-] (or [++]/ [--]) buttons. (This parameter affects the post-rotary simulator
signals as well as the pre-rotary simulator signals sent to the ROTARY TONE CABINET connector.)
Audio XRot
Out Level: 0-127
This parameter allows you to set the external rotary (pre-rotary simulator) output level when an external
rotary cabinet is being used. Press [NEXT] to select this parameter. Use the [+] and [-] (or [++]/[--]) buttons.
Audio XRot
Rotary Sig: On, Off
This parameter allows you to turn the non-rotating, pre-rotary simulator Drawbar signal on and off. Press
[NEXT] to select this parameter. Use the [+] and [-] buttons.
132
Advertisement
Table of Contents
