Table of Contents
Advertisement
Appendix
Format HD Dsk (+)
This parameter allows you to format a 2HD (high density) floppy disk. Press [NEXT] to select this
parameter. Press [+] to execute (format the disk).
Format HD Fst (+)
This parameter allows you to fast format a 2HD (high density) floppy disk. Press [NEXT] to select this
parameter. Press [+] to execute (format the disk). (A fast format is essentially just to erase all files and sub-
directories from the disk.)
Format DD Dsk (+)
This parameter allows you to format a 2DD (double density) floppy disk. Press [NEXT] to select this
parameter. Press [+] to execute (format the disk).
Format DD Fst (+)
This parameter allows you to fast format a 2DD (double density) floppy disk. Press [NEXT] to select this
parameter. Press [+] to execute (format the disk). (A fast format is essentially just to erase all files and sub-
directories from the disk.)
Update System (+)
This parameter allows you to update the W-5000's system software from a floppy disk. Press [NEXT] to
select this parameter. Press [+] to execute (update the system). Be sure the 'Sys Lock' is off.
Make SysDisk (+)
This parameter allows you to create a system disk (that is, to copy the W-5000's system software onto disk).
Press [NEXT] to select this parameter. Press [+] to execute (copy the system software). (This is useful for
making backup copies of your system software.)
Clear System (+)
This parameter allows you to erase the system software*. Press [NEXT] to select this parameter. Press [+] to
execute. (Take care when using this function. If you erase the system software you'll have to load new
system software from disk the next time you turn on the instrument.) The 'Sys Lock' must be off before you
can execute this function.
* Note that this parameter is used primarily for field service situations.
SW Version
This display indicates the version of the installed operating software and the sample ROM chips.
Sys Lock: On, Off
This parameter allows you to protect the system software from accidental erasure or modification. Press
[NEXT] to select this parameter. Use [+]/[-] to turn the Lock switch on and off.
Run Utility (+)
This parameter - used for test purposes only! - will function only if the disk inserted into the drive contains
a special utility program.
Upper Sens: Low, Norm, High
This parameter allows you to select a velocity sensitivity setting for the Upper manual. Press [NEXT] to
select this parameter. Press [+] and [-] to select the desired setting.
Lower Sens: Low, Norm, High
This parameter allows you to select a velocity sensitivity setting for the Lower manual. Press [NEXT] to
select this parameter. Press [+] and [-] to select the desired setting.
Pedal Sens: Low, Norm, High
This parameter allows you to select a velocity sensitivity setting for the Pedalboard. Press [NEXT] to select
this parameter. Press [+] and [-] to select the desired setting.
137
Advertisement
Table of Contents
