Rodgers W-5000 User Manual page 15

1 MIXED LINE
2 RODGERS
3 AUX INPUT
4 RODGERS
5 AUX INPUT
6 SYNTH
OUTPUT
7 DRAWBAR
OUTPUT
8 CLASSIC
OUTPUT
9 MIXED SPKR
10 MIXED LINE
11 MIDI 1
12 MIDI 2
13 SW1
14 PEDAL
15 ACC POWER
16 ROTARY TONE
CABINET
17 SPEAKER/
EXPRESSION
PEDAL
18 MAIN POWER
These XLR connectors allow you to connect your W-5000 to a mixing console BALANCED
INPUT (using long cables if necessary). The signal from these connectors is a Line level mix
of the individual outputs (SYNTH, DRAWBAR and CLASSIC).
This is the standard Rodgers connector for the main individual outputs MAIN
OUTPUT(SYNTH, DRAWBAR and CLASSIC) and the MIXED LINE or SPKR OUTPUT.
It also sends a 'power on' signal to any connected amplifier(s).
These XLR inputs accept connection of microphones, external keyboards etc. Sensitivity and
other controls are accessible through the [AUDIO] button in the FUNCTIONS section.
This is the standard Rodgers connector for MIXED LINE Output. It also sends a
ANTIPHONAL OUTPUT 'power-on' signal to any connected amplifier(s).
These 1/4" inputs accept connection of microphones, sound modules, external keyboards etc.
Sensitivity and other controls are accessible through the [AUDIO] button in the
FUNCTIONS section.
These 1/4" jacks provide an individual, line-level output for sounds from the Synth tone
generator. For the best results, use both jacks.
These 1/4" jacks provide an individual, line-level output for sounds from the Tone-Wheel
generator. For the best results, especially when the Rotary simulator is active, use both jacks.
These 1/4" jacks provide an individual, line-level output for sounds from the Classic Organ
tone generator. For the best results, use both jacks.
These 1/4" jacks provide a line-level output for the same signals going to the OUTPUT
internal amplifier and speakers (the Speaker mix).
These 1/4" jacks provide an option for connection to a mixing console (an OUTPUT optional
Line mix output).
These MIDI ports allow you to connect your W-5000 to external MIDI devices (such as
sound modules, sequencers etc.). Control of these ports is accessed through the [MIDI]
buttons found in each section (UPPER/LOWER/BASS) and the [MIDI] button in the
FUNCTIONS section.
Same as MIDI Port 1 without the THRU connector.
This 1/4" jack accepts connection of an external, switched (on/off) controller. The function
of this controller is user defined.
This 1/4" jack accepts connection of an external controller (such as an Expression pedal).
The function of such a controller is user defined.
This is a general purpose 12v DC power outlet. It can be used to power an external piece of
equipment (like a Rodgers PR-300, for example).
This multi-pin connector is used to connect a rotary tone cabinet to your W-5000.
This multi-pin connector is used to connect the on-board speakers and Expression pedal
(both integrated into the stand) to the keyboard.
Connect the included AC power cord to this inlet.
Introduction & Installation
15