Table of Contents
Advertisement
Appendix
Filter: 0-7
This parameter allows you to set the level of the pre low-pass filter. Press [NEXT] to select this parameter.
Set the level with the [+]/[-] buttons.
Feedback: 0-127
This parameter allows you to set the Synth chorus feedback level. Press [NEXT] to select this parameter. Use
the[+]/[-] (or [++]/[--]) buttons to set the feedback level.
Delay: 0-127
This parameter allows you to set the Synth chorus delay level. Press [NEXT] to select this parameter. Use
the[+]/[-] (or [++]/[--]) buttons to set the delay time.
Rate: 0-127
This parameter allows you to set the Synth chorus rate (speed). Press [NEXT] to select this parameter. Use
the[+]/[-] (or [++]/[--]) buttons to set the rate.
Depth: 0-127
This parameter allows you to set the Synth chorus depth. Press [NEXT] to select this parameter. Use
the[+]/[-] (or [++]/[--]) buttons to set the depth.
Reverb Send: 0-127
This parameter allows you to set the amount of post-chorus signal being mixed back into the reverb input.
Press [NEXT] to select this parameter. Use the [+]/[-] (or [++]/[--]) buttons.
[TRANSPOSE] Parameter
This parameter affects the transpose function. Press the [TRANSPOSE] button in the EFFECTS section to
access this parameter:
Transpose
Pitch: C#-1-B0
This parameter allows you to set the amount of pitch transposition (in semitone steps). Use the [+]/[-] buttons
to set the transposition; 'C0' is standard pitch. (You can also set the transposition by holding down the
[TRANSPOSE] button (in the 'on' position) and pressing a key (on any keyboard) relative to Middle 'C'.)
121
Advertisement
Table of Contents
