Table of Contents
Advertisement
Appendix
[PRESETS] Parameters
These parameters control a number of housekeeping functions related to General Presets and Global data.
Press the [PRESETS] button in the FUNCTIONS section to access these parameters:
Pist Kybd: All, Upper, Lower, Pedal
This parameter allows you to recall only those settings in a General Preset that pertain to one particular
keyboard. Use the [+]/[-] buttons to select the desired keyboard.
Reset All (+)
This parameter resets all the W-5000's internal parameters. Be careful when you use this function as it will
replace all of your custom settings with the unit's factory defaults! Press [+] to execute. (Can be protected by
the 'Reset Lock'.)
Reset Memory (+)
This parameter resets the selected internal memory to factory defaults. Press [NEXT] to select this parameter.
Press [+] to execute. (Can be protected by the 'Reset Lock'.)
Reset Preset (+)
This parameter resets the selected General Preset (Piston) to the factory default settings. Press [NEXT] to
select this parameter. Press [+] to execute. (Can be protected by the 'Reset Lock'.)
Reset Global (+)
This parameter allows you to reset global parameters to their original factory settings. Press [NEXT] to select
this parameter. Press [+] to execute. (Can be protected by the 'Reset Lock'.)
Reset Cancel (+)
This parameter allows you to reset the [CANCEL] button to its original default setting. Press [NEXT] to
select this parameter. Press [+] to execute. (Can be protected by the 'Reset Lock'.)
Reset Lock: On, Off
This parameter allows you to enable/disable the Reset functions. Press [NEXT] to select this parameter.
Press [+]/[-] to turn the Lock 'On' or 'Off'.
Read Globals (+)
This parameter allows you to re-read the global settings stored in the internal, non-volatile memory, thus
resetting any changes you've made to the individual settings since the instrument was turned on (or since you
last wrote the globals). Press [+] to execute.
Write Globals (+)
This parameter allows you to write the global settings into the internal non-volatile memory, thus recording
any changes you've made to the individual settings so they'll still be there next time you turn the instrument
on. Press [+] to execute.
Load Globals (+)
This parameter allows you to read global parameters from disk. Press [NEXT] to select this parameter. Press
[+] to execute.
127
Advertisement
Table of Contents
