Table of Contents
Advertisement
Introduction & Installation
The speakers, Expression pedal and the Pedalboard must be connected to the keyboard. Find the multi-plug
connector (which is located in the channel of the leg) and connect it to the receptacle above and to the left of
the MAIN POWER inlet. (See graphic on the previous page.) Once both the power cord and the
speaker/Expression pedal/Pedalboard cable are secure, tuck the cables inside the channel and close the cover.
Once the instrument is fully assembled, move it carefully into its final position (if it isn't already there). Be
sure the instrument is sitting on a very solid, stable floor or stage. (If necessary, stabilize the instrument by
rotating the adjustable feet on the bottom of the unit.) Remember to leave enough space behind the
instrument so that you can easily access the rear panel. Connect the power cord to a wall outlet. (Be sure the
voltage of your power outlet matches the requirement of your instrument! And never attempt to modify the
power cord; DO NOT remove the ground pin (the third prong) from the plug.)
21
Advertisement
Table of Contents
