Channel Reassignment; Octave Transpose; Enabling/Disabling Midi Master Channels - Rodgers 445E Owner's Manual

To change the coupler back to detected velocity, repeat steps 1 and 2 under "Velocity
Information." The velocity status of the Great and Swell MIDI couplers will be stored in the
combination action of the organ.
CHANNEL REASSIGNMENT
All MIDI couplers transmit on fixed channels except MIDI ON GREAT. To reset the transmit
channel for this coupler only:
1. Hold SET and press the bottom of MIDI ON GT. It will flash. Release SET and MIDI
ONGT.
2. Hold piston 1, and press any key on the Great manual between low C and tenor D# to
signify the desired MIDI channel. Low Cis Channell, low C# is Channel2, etc. The
MIDI ON GT coupler will stop flashing.
The new Great MIDI Channel assignment will be stored in the combination action of the organ.
OCTAVE TRANSPOSE
Normally, all MIDI couplers play at standard pitch (middle C =note 60). The Octave Transpose
parameter may be reset to cause any MIDI coupler to play one octave above or below standard pitch.
1. Hold SET and press the bottom of the desired MIDI coupler. It will flash. Release SET
and the MIDI coupler.
2. To transpose up one octave, turn the TRANS POSER knob to + 1, + 2,
+
3 or +4.
3. To transpose down one octave, turn the TRANSPOSER knob to -1, -2, -3 or -4.
4. Exit this mode by pressing General Cancel.
5. Return the TRANSPOSER to the desired setting.
The Octave Transpose status of each MIDI coupler will be stored in the combination action of
the organ.
ENABLING/DISABLING MIDI MASTER CHANNELS
The following MIDI channels are used to control the organ through MIDI:
Great Master Channel 12
Swell Master Channel 13
Pedal Master Channel 14
The organ sends and receives MIDI information on these channels unless they are disabled.
10