Driver Information Center Messages - Cadillac Escalade Owner's Manual

AKENG44_Escalade Page 65 Wednesday, July 16, 2008 12:22 PM
EXITING PROGRAMMING
MODE
To exit programming mode, do
any of the following:
• Turn off the ignition.
• Press the driver information
center trip/fuel information
button or vehicle information
button.
• Press the customization
button repeatedly until the
following message appears on
the display:
- PRESS TO EXIT FEATURE
SETTINGS
- Press the button to exit the
menu.
• Do not press any buttons.
The display will time out after
40 seconds of inactivity.
Driver Information Center
Messages
These messages will appear if a
problem is sensed in one of your
vehicle's systems or to display
system information.
If there is more than one message,
the messages will appear one
behind the other.
Clear any warning messages on
the Driver Information Center by
pressing any of the four Driver
Information Center buttons
located on the instrument panel,
to the right of the steering wheel.
Clearing a message only makes the
message disappear. It does not
eliminate the problem. Be sure to
take messages seriously.
Section 1
Some messages may not be
cleared until the problem is fixed.
• CALIBRATING: DRIVE IN
CIRCLES
Appears when the compass is
being calibrated.
To calibrate the compass, drive
your vehicle in a 360° circle at a
speed of 8 km/h or less.
See the following, earlier in this
section, for more information:
- Vehicle Information Menu
PRESS TO CALIBRATE
COMPASS
65 . . .
–