Table of Contents
Advertisement
Quick Links
Sta-Rite Pool/Spa Group
293 Wright Street, Delavan, WI 53115
International: 262-728-5551, FAX: 262-728-7550
www.starite.com
Union City, TN • Delavan, WI • Mississauga, ON
© 2005, Sta-Rite Industries
MAX-E-PRO
CENTRIFUGAL PUMPS
WITH INTEGRAL TRAP
O
W
N
E
R '
INSTALLATION, OPERATION & PARTS
Series P6RA, P6EA, and P6E
See Page 2 for Model Numbers
TM
S
M
A
N
U
A
L
This manual should be furnished to
the end user of this pump; its use will
reduce service calls and chance of
injury and will lengthen pump life.
S691 (Rev. 11/18/05)
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for STA-RITE MAX-E-PRO P6RA Series
Summary of Contents for STA-RITE MAX-E-PRO P6RA Series
- Page 1 Sta-Rite Pool/Spa Group 293 Wright Street, Delavan, WI 53115 International: 262-728-5551, FAX: 262-728-7550 www.starite.com Union City, TN • Delavan, WI • Mississauga, ON S691 (Rev. 11/18/05) © 2005, Sta-Rite Industries...
-
Page 2: Table Of Contents
READ THIS one of the following signal words and be alert to the po- MANUAL CAREFULLY! tential for personal injury. The Sta-Rite ‘P6RA’, ‘P6EA’ and ‘P6E’ Series Self-priming Centrifugal pumps: warns about hazards that will cause death, serious personal •... -
Page 3: Safety Instructions
NOTICE: These parameters apply to Sta-Rite equipment only. For non-Sta-Rite equipment, consult manufacturer. NOTICE: Port threads are: Internal - 2" NPT for direct connection to pipe. External - 3-1/4" Buttress. Fits Sta-Rite U11-200P Union Collar for quick disconnect pipe connection. See Page 12 for Union Kits. - Page 4 To avoid airlocking, slope suction pipe slightly upward Fire and burn hazard. Modern motors run at toward the pump. high temperatures. To reduce the risk of fire, do not allow NOTICE: To prevent flooding when removing pump for leaves, debris, or foreign matter to collect around the service, all flooded suction systems must have gate valves pump motor.
-
Page 5: Electrical
Testing and Certification ELECTRICAL Ground motor before Suction outlet covers must have been tested by a nation- connecting to electrical ally recognized testing laboratory and found to comply power supply. Failure to with the latest ASME/ANSI Specification for Suction ground motor can cause se- Fittings For Use in Swimming Pools, Spas, Hot Tubs, and vere or fatal electrical shock Whirlpool Bathtub Applications. - Page 6 Bond motor to pool structure. Use a solid copper con- To Wire a Dual-Voltage Motor ductor, size No. 8 AWG (8.4 sq.mm) or larger. Run wire Dual voltage motors have a plug to change from 230 volts from external bonding lug (see Figure 3) to (factory setting) to 115 volts.
- Page 7 TABLE I - RECOMMENDED FUSING AND WIRING DATA – P6E MODELS Serv. to Motor - Dist. in Ft. (M) Motor Branch Fuse Max Load Voltage/ 0-100' 101-200' 201-300' Rating Amps* Amps Hz/Phase (0-30 M) (30-60 M) (60-90 M) P6E Models: 11.0 115/60/1 14(2)
-
Page 8: Operation
OPERA TION If pump is not in a flooded suction system, remove trap cover handle ring and trap cover; fill trap and pump with NEVER run pump dry. Running pump dry may water. damage seals, causing leakage and flooding. Fill Do not lubricate the trap cover O-Ring. -
Page 9: Storage/Winterizing
Pump should only be serviced by qualified personnel. wrenches)! Use a rubber mallet only if necessary to re- For best results, use only genuine Sta-Rite factory parts. move cover! If pump is not anchored, use caution not to break attached piping! Be sure to prime pump (Page 8) before starting. - Page 10 If shaft seal is worn or damaged, repair as follows: ramic seat into seal plate firmly and squarely with finger pressure (Figure 5). Pump Disassembly/Removing Old Seal 2. If ceramic seat will not locate properly, remove it, Disconnect power to pump motor. place face up on bench and reclean cavity.
-
Page 11: Troubleshooting Guide
TROUBLESHOOTING Electrical: 9. Pump may be running too GUIDE slowly; check voltage at Read and understand safety and operating instruc- motor terminals and at tions in this manual before doing any work on meter while pump is run- pump! ning. If low, see wiring in- structions or consult Only qualified personnel should electrically test power company. -
Page 16: Warranty
• Complete a warranty registration at www.staritepool.com by clicking on “Register Products” and selecting Sta-Rite Pool OR • Complete bottom portion completely and mail within 10 days of installation to Sta-Rite, Attn.: Pool Warranty Dept., 293 Wright St., Delavan , WI 53115 Warranty Registration Card ■...
Need help?
Do you have a question about the MAX-E-PRO P6RA Series and is the answer not in the manual?
Questions and answers