Factory Restore - DigiTech RP360 Owner's Manual

Digitech guitar multi-effects processors
Hide thumbs Also See for RP360:
Table of Contents

Advertisement

Factory Restore

This system option is used to restore all RP
presets and system settings back to their factory
default state�
WARNING! Performing the factory restore procedure will restore all user presets back to their
factory default state� Any changes you have made and stored to user presets will be lost! Once
performed, this procedure is irreversible�
To perform the factory restore procedure:
1�
Press the
SYSTEM
2�
Press either the
the upper right-hand corner of the LCD display�
3�
Turn the
EDIT 2
4�
Press and hold the
the "Resetting���" prompt in the LCD display� Wait for the factory restore procedure to finish�
5�
If using an RP360, the procedure is now complete� If using an RP360XP, you must proceed to
the next step to calibrate the expression pedal�
6�
Once complete, you will be prompted to calibrate the expression pedal (RP360XP only)� Follow
the on-screen instructions� See Calibrate Pedal on page 52 for instructions on performing
this calibration procedure�
button�
knob or
SELECT
SYSTEM
(
) knob to initiate the factory restore procedure�
FACTORY RESTORE
knob to confirm the action� The device will now reset, indicated by
SELECT
1
Plexi-Drive
SYSTEM SETTINGS
CALIBRATE
LOOPER READY
PEDAL
START
button repeatedly until the LCD display reads 4/4 in
RP360 / RP360 XP
4/4
FACTORY
FIRMWARE
RESTORE
VERSION
START
v 1.1.0.0
53

Advertisement

Table of Contents
loading

Table of Contents