Konica Minolta bizhub 751 Quick Manual page 22

Authentication Unit (IC Card Type AU-201)
Carefully read this information, and then store it in a safe place.
- Before using this device, carefully read this information and follow it to operate the device correctly.
- After reading this information, store it in the designated holder with the warranty.
Important information
The reprinting or reproduction of the content of this publication, either in part or in full, is prohibited without
prior permission.
The content of this publication is subject to change without notice.
This publication was created with careful attention to content; however, if inaccuracies or errors are noticed,
please contact your sales representative.
The marketing and authorization to use the our company's product mentioned in this information are
provided entirely on an "as is" basis.
Our company's assumes no responsibility for any damage (including lost profits or other related damages)
caused by this product or its use as a result of operations not described in this information. For disclaimers
and warranty and liability details, refer to the User's Guide Authentication Unit (IC Card Type AU-201).
This product is designed, manufactured and intended for general business use. Do not use it for applications
requiring high reliability and which may have an extreme impact on lives and property. (Applications requiring
high reliability: Chemical plant management, medical equipment management and emergency
communications management)
Use with other authentication devices is not guaranteed.
In order to incorporate improvements in the product, the specifications concerning this product are subject
to change without notice.
For safe use
Do not this product near water, otherwise it may be damaged.
Do not cut, damage, modify or forcefully bend the USB cable. A mal-
function may occur as a result of a damaged or cut USB cable.
Do not disassembly this device, otherwise it may be damaged.
Caution
Do not store the IC card within 40 mm of the card scanning area.
Regulation notices
USER INSTRUCTIONS FCC PART 15 - RADIO FREQUENCY DEVICES (For U.S.A. Users)
FCC: Declaration of Conformity
Product Type
Product Name
This device complies with Part 15 of the FCC Rules
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any in-
terference, including interference that may cause undesired operation of this de-
vice.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interface by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
751/601
Authentication Unit (IC Card Type)
AU-201
x-21