Cerner Classic Configuration - Metrologic MS1633 FocusBT Installation Manual

Metrologic MS1633 Scanner Setup (USB CodeXML Modem)

Cerner Classic Configuration

If you are installing your MS1633 scanner using the USB CodeXML Modem on your PC running
in a Cerner Classic environment please perform the following steps. If you are installing your
MS1633 scanner using the Metrologic USB Bluetooth adapter please move to that section of
this document as the instructions in this section are not designed for your scanner.
1) Connect the USB interface cable to the CodeXML Modem and to an unused USB port
on the PC or thin client.
2) Make sure your scanner is fully charged and powered on.
3) Scan the following barcode in the order they appear.
8 MS1633 Focus BT Scanner Installation Guide
© Cerner Confidential and Proprietary All rights reserved. This document contains confidential information, which may not be
reproduced or transmitted without the express written consent of Cerner Corporation.
Factory Defaults
³ 9 9 9 9 9 8
Enter/Exit Config Mode
³ 9 9 9 9 9 9