MS1633 FocusBT Connection Setup (Continued)
34) In the Metrologic SoftWedge Utility window under
your scanner is connected to. This port was established at the end of the "Add a New
Connection Wizard" in the beginning of the FocusBT Connection Setup section.
Port Selected
35) Next to "
Connected
" will be replaced by a green "
© Cerner Confidential and Proprietary All rights reserved. This document contains confidential information, which may not be
reproduced or transmitted without the express written consent of Cerner Corporation.
" Click the Box. At this point you will notice that the red "
Connected
MS1633 Focus BT Scanner Installation Guide
Comm Port
select the COMM port
OK
" Click
to close the window.
Not
25