Led And Beep Meanings - Metrologic MS1633 FocusBT Installation Manual

LED and Beep Meanings

The MS1633 has three LED indicators (yellow, white and blue) located on the top of the
scanner. When the scanner is on, the flashing or stationary activity of the LED's indicates the
status of the current scan and the scanner. The Beep also indicates the status of the scans.
Normal Operation Feedback
LED Beep
None
Steady Yellow
Steady Blue
Steady Blue &
Single White Flash
Steady White
Alternating
Flashing Blue and
White
Flashing Blue
Long Razzberry
Short Razzberry
White LED Flash
3 beeps – Med /
Flashing Blue
© Cerner Confidential and Proprietary All rights reserved. This document contains confidential information, which may not be
reproduced or transmitted without the express written consent of Cerner Corporation.
Meaning
None Scanner not powered on or no barcode being scanned.
None Scanner is in the presentation stand.
The blue LED is illuminated when the scanner is active and linear
None
illumination is on or when the scanner is attempting to decode a
barcode.
1 Beep When the scanner successfully reads a bar code it will beep once and
the White LED will turn on indicating data is being transmitted.
When the scanner successfully reads a bar code it will beep once and
1 Beep
the White LED will turn on indicating data is being transmitted. If the
host is not ready to accept the information, the scanner's white LED
will remain on until the data can be transmitted.
This indicates the scanner is in configuration mode. A short razzberry
None
tone indicates that an invalid bar code has been scanned while in this
mode.
None The blue LED will flash if the trigger is pressed while the scanner is in
the in-stand presentation mode. The blue LED will stop flashing after a
brief period of time.
Failed to initialize or configure the scanner. If the scanner does not
respond after reprogramming, return the scanner for repair.
Tone – During
Power Up
An Invalid bar code has been scanned when in configuration mode or
the trigger has been pulled too fast.
Tone – Durring
Scanning
3 Beep after Scanner ready for use.
power up
3 Beeps in Scanner has entered configuration mode.
Configuration
Mode
When using single code configuring this 3 beeps indicate that the
barcode successfully configured the scanner.
High / Low
3 Beeps in Communication Error
Normal Mode
Bluetooth connection has been made
2 beeps Low /
High
2 beeps High / Bluetooth connection has been disconnected
Low
Double Razz When the Bluetooth communication link is not active, the scanner will
emit a double razz tone and the Blue LED will start to flash. This can
Tone
occur when the scanner is out of Bluetooth communication range from
the host system and the RangeGate feature is disabled.
MS1633 Focus BT Scanner Installation Guide 5