Table of Contents
Advertisement
Failure to carry out the operations described in the table may lead to technical damage to the machine and/or system
MAINTENANCE
SUMP OIL LEVEL CHECK
OIL BATH AIR CLEANER CLEANING
DRY AIR CLEANER CHECKING
OIL CARTER REPLACEMENT (4)
OIL FILTER REPLACEMENT
FUEL FILTER REPLACEMENT
COOLING FINS CLEANING
SETTING ROCKER ARMS CLEARANCE
SETTING AND INJECTORS CLEANING
OVERALL INSPECTION PARTIAL
OVERALL INSPECTION COMPLETE
(1) After the first 50 working hours
(2) In case of low use: every 6 months
(3) In case of low use: every 12 months
(4) If you are using oil of a quality lower than the recommended one then you will have to replace it every 150 hours
The maintenance operations listed above refer to an engine operating in normal conditions (temperature, degree of humidity,
dust in the working environment). They may vary significantly according to the type of use.
To avoid explosions or fire outbreaks, do not smoke or use naked flames during the operations.
Fuel vapours are highly toxic. Only carry out the operations outdoors or in a well ventilated place.
Keep your face well away from the plug to prevent harmful vapours from being inhaled. Dispose of fuel in the correct
way and do not litter as it is highly polluting.
FUEL
When refuelling, it is advisable to use a funnel to prevent fuel from spilling out. The fuel should also be filtered to prevent dust or
dirt from entering the tank.
Use the same type of diesel fuel as used in cars. Use of other types of fuel could damage the engine. The cetane rating of the
fuel must be higher than 45 to prevent difficult starting. Do not use dirty diesel fuel or mixtures of diesel fuel and water since this
would cause serious engine faults.
The capacity of the standard tank is: lt. 5,0
Workshop Manual KD500 _ cod. ED0053029390 - 1° ed_rev. 00
MAINTENANCE - RECOMMENDED OIL TYPE - REFILLING
OPERATION
INTERVAL (HOURS)
10
50
250
500
2500 5000
(1)
(2)
(3)
8
- 15 -
- 15 -
Advertisement
Table of Contents
