Plinth (Toekick) - Removal; Front Panel - Removal; Side Panel - Removal - Miele Touchtronic T1302 Technical Information

Technical Information
4.2 Toekick Removal
1. Remove the screw caps, Figure 010-1.
2. Remove the screws.
3. Slide the toekick to the left; pull from the appliance to remove.
4.3

Front Panel - Removal

1. Open the door.
2. Remove the two Door Lock screws.
3. Remove the five screws around the door opening.
4. Remove the toekick (010 4.2).
5. Support the panel from the bottom. Remove the two screws
from the bottom corners of the panel.
6. Guide the panel downward to remove it from the appliance.
4.4

Side Panel - Removal

1. Remove the Lid (010 4.1).
2. Remove the Front Panel (010 4.3).
3. Refer to Figure 010-1. Remove the three screws from both rear
edges of the panel.
4. Remove the three screws from the top edge of the panel.
5. Remove the three screws from the front edge of the panel.
6. If equipped - remove the dryer vent (or cap).
7. Pull the panel outward from the top.
8. Push the panel down to unclip it from the bottom of the frame.
Reassembly Note
Install the panel at the bottom first. Ensure the lip on the panel
engages with the frame of the appliance. The 2 middle screws /
washers provide the ground to the panels. Ensure they are tight
during reassembly.
T1302, T1303, T1322, T1329ci, T1323c,
T1403 and T1405 Clothes Dryers
16